Loading ...
Loading ...
Loading ...
50 Servicing Your Honda
Fuel Tank
14. Check for interference between the frame and
tank, and adjust the cushion rubbers (23) on the
both sides of the frame if necessary.
NOTICE
Do not ride your motorcycle in state which the
cushion rubbers have been removed.
It may cause the fuel tank cracking.
Installation
1. Make sure the rubber cover (1) is onto the fuel
joint (2) of the fuel pump as shown.
2. Be sure that the slide retainer (3) is completely
pulled up before connecting the quick connect
fitting.
• Do not bend or twist the fuel feed hose.
• Do not reuse the kinked or damaged fuel
hose.
• Do not use gloves or a shop towel while
installing the quick connect fitting.
3. Place the fuel tank (4) onto the frame.
4. Connect the quick connect fitting to the fuel
joint (2) until you hear the “click” while
holding the connector housing (5).
If it is hard to connect, put a small amount of
engine oil on the pipe end of the fuel joint.
5. Make sure the connection is secure and that the
slide retainer is firmly locked into place; check
visually and by pulling the connector housing.
6. Install the fuel quick connect fitting cover (6).
Be sure the rubber cover (1) is properly
installed between the fuel quick connect fitting
cover and fuel pump.
(23) cushion rubbers
3.35 ± 0.10 in
(85.0 ± 2.5 mm)
(23)
1.10 ± 0.10 in
(28.0 ± 2.5 mm)
(1) rubber cover
(2) fuel joint
(3) slide retainer
(1) (2)
(3)
(2) fuel joint (4) fuel tank
(3) slide retainer (5) connector housing
(1) rubber cover
(6) fuel quick connect fitting cover
(3)
(4)
(2)
(5)
(1)
(6)
31MKE910.book 50 ページ ２０１９年２月１４日 木曜日 午後１時４１分
Loading ...
Loading ...
Loading ...