Loading ...
Loading ...
Loading ...
142 Servicing Your Honda
Appearance Care
5. Dry your motorcycle with a chamois or a soft
towel.
Leaving water on the surface to air dry can
cause dulling and water spots. As you dry,
inspect for chips and scratches.
6. Lubricate the drive chain to prevent rusting.
7. Start the engine and let it idle for several
minutes. The engine heat will help dry moist
areas.
8. As a precaution, ride at a slow speed and apply
the brakes several times. This will help dry the
brakes and restore normal braking
performance.
There are some things you should do just after
washing your motorcycle to help prevent rust and
corrosion.
Once your motorcycle is clean and dry, you should
protect any bare steel from rusting by applying a
light coating of a rust-inhibitor. Lubricate the drive
chain and drive sprocket after removing and
thoroughly cleaning in solvent. Be sure the chain is
wiped clean and is dry before applying the chain
lube.
Follow the suggestions given in the pages of this
manual for lubricating items such as the brake and
clutch lever pivot points and footpeg pivot pins.
Follow these guidelines to prevent scratches and
blemishes:
• Wash gently using a soft sponge and plenty of
water.
• To remove stubborn stains, use diluted
detergent and rinse thoroughly with plenty of
water.
• Avoid getting gasoline, brake fluid, or
detergents on the instruments, panels, or
headlight.
Aluminum corrodes when it comes in contact with
dust, mud and road salt.
To remove stains, use Scotch Brite Hand Pad
#7447 (maroon) or an equivalent.
Wet the pad and polish the surface using strokes
parallel to the length of the frame.
Clean the frame using a wet sponge and a mild
detergent, then rinse well with clean water. Dry the
frame with a soft clean cloth, using strokes parallel
to the length of the frame.
NOTICE
Do not use steel wool to clean the frame as it could
damage or discolor the frame surface.
Scotch Brite Hand Pad #7447-maroon is for
removing stains on the non-coated aluminum
frame only.
The fuel tank is made of titanium material.
To remove mud or dust, use a sponge or soft cloth
and a stainless steel kitchen detergent, then rinse
well with clean water.
After washing, rinse with plenty of water and dry
with a clean cloth.
The exhaust pipe and muffler are stainless steel but
may became stained by mud or dust.
To remove mud or dust, use a wet sponge and a
liquid kitchen abrasive, then rinse well with clean
water. Dry with chamois or a soft towel.
If necessary, remove heat stains by using a
commercially available fine texture compound.
Then rinse by the same manner as removing mud
or dust.
After Cleaning Lubrication
Panels
Aluminum Frame Maintenance
Titanium Fuel Tank Maintenance
Exhaust Pipe and Muffler Maintenance
31MKE910.book 142 ページ ２０１９年２月１４日 木曜日 午後１時４１分
Loading ...
Loading ...
Loading ...