Loading ...
Loading ...
Loading ...
26 Basic Operating Instructions
Starting & Stopping the Engine
Warm Engine Starting
1. Shift the transmission into neutral.
2. Pull the clutch lever and depress the start
button. (Do not open the throttle.)
Starting the engine excessively charged with fuel
by throttle blipping or other reasons
1. Shift the transmission into neutral.
2. With the throttle fully opened, pull the clutch
and depress the start button for 5 seconds to
discharge excessive fuel from the engine.
3. Pull the clutch lever and depress the start
button. (Do not open the throttle.)
Snapping the throttle or fast idling for more than
about 5 minutes may cause exhaust pipe and
muffler discolorations.
Your motorcycle’s banking (lean angle) sensor
system is designed to automatically stop the engine
if the motorcycle is overturned.
Before restarting the engine, you must turn the
ignition switch to the OFF position and then back
to the ON position. The engine will not restart until
you perform this procedure.
Normal Engine Stop
To stop the engine, shift into neutral and turn the
ignition switch to the OFF position.
The engine stop switch should normally remain in
the (Run) position even when the engine is
OFF.
If your motorcycle is stopped with the ignition
switch in the ON position and the engine stop
switch (Stop), the headlight, position light,
tailllight and license light will remain on, resulting
in battery discharge.
Emergency Engine Stop
To stop the engine in an emergency, use the engine
stop switch. To operate, press the switch to the
(Stop) position.
Bank Angle Sensor Ignition Cut-off
System
How to Stop the Engine
31MKE910.book 26 ページ ２０１９年２月１４日 木曜日 午後１時４１分
Loading ...
Loading ...
Loading ...