Loading ...
Loading ...
Loading ...
(219,1)
北米Model "A1380BE-A" EDITED: 2019/ 7/ 10
and streaking on the glass. If you
cannot remove those streaks after
operating the washer or if the wiper
operation is jerky, clean the outer sur-
face of the windshield or rear window
and the blade rubbers using a sponge
or soft cloth with a neutral detergent or
mild-abrasive cleaner. After cleaning,
rinse the window glass and blade
rubbers with clean water. The glass is
clean if no beads form on the glass
when you rinse with water.
. If you cannot eliminate the streaking
even after following this procedure,
replace the wiper blades (or blade
rubbers) with new ones. For replace-
ment instructions, refer to “Replace-
ment of wiper blades” F11-31.
& Windshield wiper and washer
switches
S03AM01
The wiper operates only when the ignition
switch is in the “ON” or “ACC” position.
! Operating the wiper lever
S03AM0106
: Mist operation (for a single wipe)
: Off
: Intermittent operation
: Low speed operation
:
High speed operation
For a single wipe of the wipers, push the
lever up. The wipers operate until you
release the lever.
! Wiper intermittent time control
S03AM0103
When the wiper switch is in the “ ”
position, turn the dial to adjust the operat-
ing interval of the wiper. The operating
interval can be adjusted in several steps.
– CONTINUED –
Instruments and controls/Wiper and washer
3-75
3
Loading ...
Loading ...
Loading ...