Loading ...
Loading ...
3
www.napoleongrills.com
N415-0272-AU JAN 24.18
WARNING! Failure to follow these instrucons could result in property damage, personal injury
or death. Read and follow all warnings and instrucons in this manual prior to operang grill.
Safe Operang Pracces
• This gas grill must be assembled exactly according to the instructions in the manual. If the grill
was store assembled, you must review the assembly instructions to conrm correct assembly and
perform the required leak tests before operating the grill.
• Read the entire instruction manual before operating the gas grill.
• This gas grill must be used only outdoors in a well-ventilated space and must not be used inside
a building, garage, screened-in porch, gazebo or any other enclosed area.
• This gas grill must not be installed in or on recreational vehicles and/or boats.
• Do not locate unit in windy settings. High winds adversely affect the cooking performance of the
gas grill.
• Do not modify this appliance.
• Do not operate unit under overhead combustible construction.
• Maintain proper clearance to combustibles, (
18” (457mm)
to rear of unit,
24” (610mm)
to sides).
Additional clearance of 24” (610mm) is recommended near vinyl siding or panes of glass.
• Gas must be turned off at the gas supply valve when the gas grill is not in use.
•
If the enclosure is to house a Universal Liqueed Petroleum Gas cylinder, the tank portion of the
enclosure must be ventilated according to local codes, and must not have communication with the
cavity used to enclose the gas grill. A Universal Liqueed Petroleum Gas cylinder tank cannot be
stored below the gas grill.
• When the Universal Liqueed Petroleum Gas cylinder is connected to the appliance, the gas grill
and cylinder must be stored outdoors in a well-ventilated space.
• Inspect the fuel supply hose before each use. If there is evidence of excessive abrasion or
wear or the hose is cut, it must be replaced prior to using the gas grill with a replacement hose
assembly specied by the grill manufacturer.
• Periodically check the test date on the ULPG gas cylinder to ensure it is within its service life
specication. If required, contact an approved testing facility or ULPG supplier for re-certication
or replacement.
• Leak test the unit before initial use, annually, and whenever any gas components are replaced.
• Follow lighting instructions carefully when operating grill.
• Burner controls must be off when turning supply cylinder valve on.
• The lid is to be closed during the gas grill preheating period on all models except the
BISZ300NFT/PFT and the built-in side burner BISB245.
• The BISZ300NFT/PFT and the built-in side burner BISB245 are supplied with a at cover
for storage and protection from the elements. Never place this cover on the grill while hot or
operating. Allow grill to cool completely before covering.
• Adults and especially children should be alerted to the hazards of high surface temperatures.
Young children should be supervised near the gas grill.
• Do not place articles on or against this appliance.
• Do not leave grill unattended when operating.
• Do not light burners with lid closed.
• Do not use or store ammable materials in or near this appliance.
• Do not operate rear burner with main burners operating.
• Do not move grill when hot or operating.
• Keep any electrical supply cord and fuel supply hose away from any heated surfaces.
• Do not spray aerosols in the vicinity of this appliance while it is in operation.
• Ensure sear plates are positioned properly according to sear plate installation instructions. The
holes must be towards the front of the gas grill (if applicable).
• Clean grease tray and sear plates regularly to avoid build-up, which could lead to grease res.
•
Remove warming rack before lighting rear burner. The extreme heat will damage the warming rack.
• Inspect infrared burner venturi tube for spider webs and other obstructions periodically. Clean the
tubes completely if you nd any such obstructions.
• Do not allow cold water (rain, sprinkler, hose, etc.) to come in contact with heated unit. A large
temperature differential can cause chipping in the porcelain.
• Do not allow cold water (rain, sprinkler, hose, etc.) to come in contact with ceramic burners. A
large temperature differential can cause cracking in the ceramic tile.
• Do not use a pressure washer to clean any part of the unit.
Loading ...
Loading ...
Loading ...