Loading ...
Loading ...
Loading ...
Failure to perform a reset
The system does not function properly if a reset
has not been carried out, for instance a flat tire is
reported though tire inflation pressures are cor‐
rect.
Malfunction
The yellow warning light flashes and is
then illuminated continuously. A Check
Control message is displayed. It may not
be possible to identify tire pressure losses.
Examples and recommendations in the following
situations:
▷ A wheel without TPM wheel electronics is
mounted: have it checked by a dealer’s serv‐
ice center or another qualified service center
or repair shop as needed.
▷ Malfunction: have system checked by a deal‐
er’s service center or another qualified serv‐
ice center or repair shop.
▷ The system was unable to complete the re‐
set. Perform a system reset again.
▷ Interference caused by systems or devices
with the same radio frequency: after leaving
the area of the interference, the system auto‐
matically becomes active again.
Declaration according to NHTSA/FMVSS
138 Tire Pressure Monitoring System
Each tire, including the spare (if provided) should
be checked monthly when cold and inflated to
the inflation pressure recommended by the vehi‐
cle manufacturer on the vehicle placard or tire in‐
flation pressure label. (If your vehicle has tires of
a different size than the size indicated on the ve‐
hicle placard or tire inflation pressure label, you
should determine the proper tire inflation pres‐
sure for those tires.) As an added safety feature,
your vehicle has been equipped with a tire pres‐
sure monitoring system (TPMS) that illuminates
a low tire pressure telltale when one or more of
your tires is significantly under-inflated. Accord‐
ingly, when the low tire pressure telltale illumi‐
nates, you should stop and check your tires as
soon as possible, and inflate them to the proper
pressure. Driving on a significantly under-inflated
tire causes the tire to overheat and can lead to
tire failure. Under-inflation also reduces fuel effi‐
ciency and tire tread life, and may affect the vehi‐
cle's handling and stopping ability. Please note
that the TPMS is not a substitute for proper tire
maintenance, and it is the driver's responsibility
to maintain correct tire pressure, even if under-
inflation has not reached the level to trigger illu‐
mination of the TPMS low tire pressure telltale.
Your vehicle has also been equipped with a
TPMS malfunction indicator to indicate when the
system is not operating properly. The TPMS
malfunction indicator is combined with the low
tire pressure telltale. When the system detects a
malfunction, the telltale will flash for approxi‐
mately one minute and then remain continuously
illuminated. This sequence will continue upon
subsequent vehicle start-ups as long as the mal‐
function exists. When the malfunction indicator is
illuminated, the system may not be able to de‐
tect or signal low tire pressure as intended.
TPMS malfunctions may occur for a variety of
reasons, including the installation of replacement
or alternate tires or wheels on the vehicle that
prevent the TPMS from functioning properly. Al‐
ways check the TPMS malfunction telltale after
replacing one or more tires or wheels on your ve‐
hicle to ensure that the replacement or alternate
tires and wheels allow the TPMS to continue to
function properly.
Intelligent Safety
Concept
Intelligent Safety enables central operation of the
driver assistance system.
The intelligent safety systems can help prevent
an imminent collision.
▷ Approach control warning with City light brak‐
ing function, refer to page 146.
Seite 145
Safety
CONTROLS
145
Online Edition for Part no. 01402989296 - II/18
Loading ...
Loading ...
Loading ...