Loading ...
Loading ...
Loading ...
- 4 - SUMMIT 201805 GAS OVEN
SGWO30SS MANUAL
Use care when opening door. Let hot air or steam escape before removing or replacing
food.
Do not heat unopened food containers. Build-up of pressure may cause container to burst
and result in injury. Keep oven vent ducts unobstructed.
Placement of oven racks. Always place oven racks in desired location while oven is cool. If
rack must be moved while oven is hot, do not let potholder contact hot heating element in
oven.
In case of electrical power failure: The user must not attempt to operate the appliance
during a power failure.
Do not misuse the appliance door. Misuse of the appliance door can cause possible
hazards or injuries which may result from stepping, leaning or sitting on it.
CAUTION: Do not store items of interest to children in cabinets above the oven. Children
climbing on the oven to reach items could be seriously injured.
SAVE THESE INSTRUCTIONS
BEFORE USING THE OVEN
All products are wiped clean with solvents at the factory to remove any visible signs of dirt,
oil, and grease which may have remained from the manufacturing process. There may be
some burn-off and odors on first use of the appliance. This is normal.
OVEN
Important: Before first use, wipe interior with soapy water and dry thoroughly. Then set
the oven selector thermostat to bake at 350°F, and operate for one hour.
OPERATING THE GAS OVEN
OVEN GAS BURNER IGNITION, REGULATION AND THERMOSTAT
Open oven door completely (when igniting oven, if door is not open, oven cavity will fill with
gas), then push and turn the thermostat knob counter-clockwise to the MAX setting. See
figs. 01 and 02 at the back of this manual. A clicking sound will be heard and the burner
will light. Look through orifice “F” for burner ignition. Keep pushing knob to allow
thermocouple of the safety device to warm up enough, for about a period of 5 seconds.
Then release the knob and turn it to the desired temperature setting.
Attention: During first use of the oven gas burner, or after a long non-working period, the
burner may not ignite at once, so try the ignition procedure again until the flow of gas
allows ignition. If the problem persists, call an authorized technician for repair.
Loading ...
Loading ...
Loading ...