Loading ...
Loading ...
Loading ...
- 12 - SUMMIT 201805 GAS OVEN
SGWO30SS MANUAL
- The flexible cord must be held tight by the cord lock, in such a way that it may not be
pulled out. The flexible cord path must not be in proximity or in contact with hot
surfaces that may damage the cord itself.
ATTENTION: The flexible cord must be in accordance with National Electrical Codes
and suitable for the electrical characteristics of this oven. (See Wiring Diagram,
page 19.) THE MANUFACTURERS DECLINE ANY RESPONSIBILITY FOR
IMPROPER INSTALLATION, ADJUSTMENT, ALTERATION, SERVICE,
MAINTENANCE OR USE OF RANGE WHICH CAN RESULT IN SERIOUS INJURY
OR PROPERTY DAMAGE.
Gas Supply
Installation of this range must conform with local codes or, in the absence of local codes,
with the National Fuel Gas Code, ANSI Z223.1 latest edition.
In Canada the range must be installed in accordance with the current CGA Standard
CAN/CGA-B149 – Installation Codes for Gas Burning Appliances and Equipment and/or
local codes.
Gas Supply Connection (See figure 10):
A TRAINED SERVICEMAN OR GAS APPLIANCE INSTALLER MUST MAKE THE GAS
SUPPLY CONNECTION. Leak testing of the appliance must be conducted by the
installer according to the instructions given in section (h).
Natural gas supply line must have a natural service regulator. Inlet pressure to this
appliance should be reduced to a maximum of 7 inches water column. Liquefied Petroleum
L.P. / Propane gas supply line must have a L.P. gas pressure regulator. Inlet pressure to
this appliance should be reduced to a maximum of 14 inches water column.
Inlet pressure in excess of 14 in. W.C. can damage the appliance pressure regulator or
other gas components in this appliance, and can result in a gas leak.
a) A manual gas valve should be put in an accessible location in the supply line ahead of
the appliance, for turning on and turning off gas supply. If oven is to be connected to
house piping with flexible or semi-rigid metal connectors for gas appliances, connector
nuts must not be connected directly to pipe threads. The connectors must be installed
with adapters provided with the connector.
b) The house piping and/or range connector used to connect the oven to the main gas
supply must be clean, free of metal shavings, rust, dirt and liquids (oil or water). Dirt in
the supply lines can work its way into the range manifold and in turn cause failure of
the gas valves or controls and clog burners and/or pilot orifices.
CAUTION: DO NOT LIFT OR MOVE THE OVEN BY DOOR HANDLE.
c) Turn off all pilots and main gas valve of other gas appliances.
d) Turn off main gas valve at meter.
e) Before connecting the oven, apply pipe thread compound approved for LPG to all
threads.
Loading ...
Loading ...
Loading ...