Loading ...
Loading ...
Loading ...
- 11 - SUMMIT 201805 GAS OVEN
SGWO30SS MANUAL
Electrical Installation
This appliance must be plugged into a properly grounded three-hole single-phase 120
VAC - 60 Hz 15 amps electrical outlet.
NOTE: House wiring and fusing must comply with local codes. If no local codes are
applicable, wire in accordance with the National Electrical Code, ANSI/NFPA 70, latest
edition.
The three-prong grounding plug offers protection against shock hazards. DO NOT CUT
OR REMOVE THE THIRD GROUNDING PRONG FROM THE POWER CORD PLUG.
If an ungrounded, two-hole or other type of electrical outlet is encountered, it is the
personal responsibility of the appliance owner to have the outlet replaced with a properly
grounded three-hole electrical outlet.
The cable cord connected to the appliance is flexible. Pass it through the hole prepared in
the cabinet to plug it into the wall socket.
To facilitate service, the flexible cable must not be shortened and should be routed to
permit temporary removal of the appliance.
Assembly/Replacement of the Power Supply Cable
The electric cable must be kept locked to the terminal box so that it cannot be removed.
Connect the line cable to terminal “L”, the neutral cable to terminal “N” and the
yellow/green cable to the ground terminal (fig.n°09). The yellow/green cable must be
longer than the other two by at least 20 mm (about ¾”). Ensure the electric cable does not
pass near or come into contact with the surfaces reaching a temperature above 75°C
(167°F).
Grounding
IMPORTANT: Local codes might vary. Installation, electrical connections and grounding
must comply with all applicable local codes.
WARNING: This appliance requires ground connection for your protection against shock
hazard and should be connected directly into a properly grounded receptacle.
WARNING: DISCONNECT ELECTRICAL SUPPLY BEFORE SERVICING THE
APPLIANCE.
When the flexible cord has to be changed it is necessary to follow the procedure described
here:
- Turn off main gas shut-off valve and disconnect electrical supply.
- Pull out entire range from the counter.
- Disconnect gas supply connector from appliance gas manifold.
- Open up connecting terminal block cover.
- Open flexible cord lock and loosen up old cord prongs from terminal block.
- Connect new flexible cord prongs to terminal block and fix flexible cord lock.
Remember the ground wire (yellow and green) must be longer by about one inch than the
other ones. For Line and Neutral wire connection, follow signs on terminal block.
Loading ...
Loading ...
Loading ...