Loading ...
Loading ...
Loading ...
Page:
9
User Manual:
Installation Instructions (Continued)
INSTALLING THE COOKTOP
Cut a hole in your benchtop that corresponds with the relevant cut-out size for your Esatto Cooktop model. Refer to the
“Your Esatto Cooktop” section of this user manual.
IMPORTANT! You must have a gap of at least 30mm between the underside of the cooktop and any
surface below.
→ Carefully turn the cooktop upside down and place it on a cushioned mat.
→ Apply the sealing strip provided, around the edge of the appliance, and remove the
protective covering.
Note: It’s important not to leave a gap in the sealing strip, whilst at the same time
ensuring that no sections overlap.
IMPORTANT! Don’t use a silicone sealant to seal the appliance against the benchtop. This will make it
dicult to remove the cooktop in the future should it require servicing.
→ With the cooktop still upside down, place the clamps supplied over the holes that match
the size of the screws. There are a set of screw holes in each corner of the cooktop.
Slightly tighten each screw through the clamp, so that the clamp is attached to the
cooktop, but loose enough that you can still adjust it’s position.
→ Now carefully turn the cooktop back over and gently lower it into the cut-out.
→ On the underside of the cooktop, adjust the clamps into a position that is suitable to
secure it to your benchtop. Now you can fully tighten the screws to secure the cooktop
into position.
Loading ...
Loading ...
Loading ...