Loading ...
Loading ...
Loading ...
Page:
12
User Manual:
Installation Instructions (Continued)
CHECKING THE GAS SUPPLY
1 Check the manometer zero point is correct.
2 Connect the manometer to the cooktop pressure point (located on the regulator).
3 Turn on the gas supply and electricity and try to ignite the gas burner.
Note: It will take additional time to light the gas for the rst time as air needs to be purged from the
pipes.
4 With the appliance operating check the outlet pressure
→ When all burners of the appliance are operating at maximum,
→ When the smallest burner of the appliance is operating at minimum.
→ Under these conditions the outlet pressure should not vary from the
nominal outlet pressure of 1.00kPa by more than ±0.20kPa.
If the regulator appears to not be performing satisfactorily, then check the following points:
1. If the outlet pressure is consistently too low then the inlet pressure may be too low and adjustment of
an upstream regulator may be needed, or an upstream regulator or valve with insucient ow capacity
may be present in the gas supply line. If this is suspected then it may be necessary to repeat the checks
whilst measuring both the inlet and outlet pressure to determine if the inlet pressure is in the range 1.13 –
5kPa.
2. Check that the regulator has been tted to the gas supply line in the correct orientation, the arrow on
the base of the body indicates the direction of gas ow.
Once these checks have been completed, if the regulator still fails to perform in a satisfactory manner it
should be replaced. Please contact the Residentia Support Team on 1300 11 4357.
Loading ...
Loading ...
Loading ...