Loading ...
Loading ...
Loading ...
Engine servicing
4-4
4-4
(1) 5P CONNECTOR
Disassembly / Installation of fuel feed hose
The pawl of the fast connector must be changed every
time the fuel feed hose is disconnected.
Disassembly of fuel pump side
Turn off the engine.
Remove the rear fender
Pull up the fuel tank
Disconnect the fuel pump’s 5P connector.
Turn on the engine until it stops.
(1) FAST CONNECTOR PROTECTOR
(1) PAWL
(2) FAST CONNECTOR
1. Remove the protective housing from the fast connec-
tor.
2. Check whether the connector is dirty and clean if ne-
cessary. Cover the fast connector with a cloth.
3. Hold fast connector with one hand and tighten the two
pins of the pawl with the other hand while pulling the
connector backwards. Disconnect the fast connector
and remove the pawl.
(1) PAWL
(2) FAST CONNECTOR
(1) PAWL
(2) FAST CONNECTOR
INSTALLATION OF FUEL PUMP SIDE
1. Insert a new pawl in the fast connector. Insert the fast
connector in the fuel pump feed hose until it clicks. If
this is hard to do, apply a small amount of motor oil to
the fuel pump feed hose.
2. Move the fast connector backwards to check that it
does not come out and is firmly connected.
3. Place the protective housing over the fast connector.
1
1
2
1
2
2
1
1
Loading ...
Loading ...
Loading ...