Loading ...
Loading ...
Loading ...
36_ Installation Instruction
Step 4. Tension adjustment of the door spring
After placed the panel on the dishwasher, please try open and close the door to test the balance to check
out whether the door can remain a same place. If not, please adjusting the screw in the direction of
clockwise or counter-clockwise to adjust the balance of the door. Or it has been adjusted.
Hexnut tools
CR-V 4 mm
Step 5. Connecting the water inlet hose (for cold water)
After placed the panel on the dishwasher, please try open and close the door to test the balance to check
out whether the door can remain a same place. If not, please adjusting the screw in the direction of
clockwise or counter-clockwise to adjust the balance of the door. Or it has been adjusted.
Connection the cold water supply hose to a threaded 3/4(inch) connector
and make sure that it is fastened tightly in place.
If the water hoses are new or have not been used for an extended period
of time, let the water run to make sure that the water is clear and free of
impurities, If this precaution is not taken, there is a risk that the water inlet
can get blocked and the appliance could be damaged.
Step 5-1. Electrical connection
Make sure the socket is compatible with the plug of the appliance, The
socket must have earthing wire, and can hold 250 V / 10 A, otherwise
damage or accidence may occur, Other electric appliance with big power
can not use the same socket with the dishwasher.
Installation instruction
DW4000KM-00000A-00_EN (Basic)_160323.indd 36DW4000KM-00000A-00_EN (Basic)_160323.indd 36 2016-03-23 1:14:342016-03-23 1:14:34
Loading ...
Loading ...
Loading ...