Loading ...
Loading ...
Loading ...
14_ Prior Using for the First Time
Loading the salt into the softener
Always use salt intended for use with dishwasher.
If your model has no water softener, you may skip this section
WATER SOFTENER
The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will
form on the dishes and utensils.
The appliance is equipped with a special softener that uses salts specifically designed to eliminate lime and
minerals from the water.
The salt container is located beneath the lower basket and should be filled as follows:
CAUTION: Only use salt specifically designed for use in dishwashers! All other types of salt not
specifically designed for use in a dishwasher, especially table salt, will damage the water softener. In
case of damages caused by the use of unsuitable salt the manufacturer does not give any warranty
nor is liable for any caused damages.
Only fill with salt just before starting one of the complete washing programmes.
This will prevent any grains of salt or salty water, which may have been split, remaining on the bottom
of the machine for any period of time, which may cause corrosion.
After the first wash cycle the control panel light expires.
1. Remove the lower basket and then
unscrew and remove the cap from the
salt container.
1 2
2. If you are fi lling the container for the fi rst time, fi ll 2/3 of its volume with water (around 500ml).
3. Place the end of the funnel (supplied) into the hole and introduce about 1.2kg of salt. It is normal for a
small amount of water to come out of the salt container.
4. Carefully screw the cap back on.
5. Usually, the salt warning light will be o in 2-6 days after the salt container is fi lled with salt.
• The salt container must be refilled when the salt warning light in the control panel comes on.
Though the salt container is filled enough, the indicator light may not black out before the salt
fully dissolve. If there is no salt warning light in the control panel (for some models), you can judge
when to load the salt into the softener by the cycles that the dishwasher had run (see the following
schema).
• If there are spills of the salt, a soak program could be run to wipe them out.
Prior using for the first time
DW4000KM-00000A-00_EN (Basic)_160323.indd 14DW4000KM-00000A-00_EN (Basic)_160323.indd 14 2016-03-23 1:14:292016-03-23 1:14:29
Loading ...
Loading ...
Loading ...