Loading ...
Loading ...
Loading ...
Fig. 14
u
Lift the stopper
Fig. 14 (50)
out of the door bearing bush and
transfer it.
u
Detach door handle
Fig. 14 (52)
, stopper
Fig. 14 (53)
and
pressure plates
Fig. 14 (54)
and transfer to the opposite
side.
u
When fitting the pressure plates on the opposite side, make
sure they snap properly into place.*
4.3.10 Fitting the lower door
u
Place the door from above onto the lower bearing pin
Fig. 13 (42)
.
u
Close the door.
u
Place the plastic cap
Fig. 11 (33)
back onto the middle turn
hinge
Fig. 11 (31)
.
u
On the new hinge side, pass the middle bearing pin
Fig. 11 (32)
through the middle turn hinge
Fig. 11 (31)
into
the lower door.
u
Attach the washer
Fig. 11 (34)
to the middle bearing pin
Fig. 11 (32)
.
4.3.11 Fitting the lower soft stop mechanism
Fig. 15
u
Remove the cover
Fig. 15 (26)
from the faceplate
Fig. 15 (20)
and re-insert it at the other side.
u
Engage the soft stop unit with the joint pointing to the hinge
side (A) and swivel into place (B).
w
The screw holes at the left and right have to register.
u
Screw the soft stop unit firmly into place(2 mal Torx® 15)
Fig. 15 (25)
.
Fig. 16
u
Attach the faceplate
Fig. 16 (20)
to the soft stop bracket so
that the catches face forwards and the front faces the appli-
ance.
u
Draw the soft stop bracket
Fig. 16 (24)
towards the bearing
element and insert the pin
Fig. 16 (23)
from above so that
the square is seated in the depression.
u
Attach and engage the cover
Fig. 16 (21)
.
w
Pay attention that the cover fits properly so that the door
closes properly and the pin is secured.
u
Twist the safety lock
Fig. 16 (22)
for removal.
u
Snap thefaceplate
Fig. 16 (20)
onto the door.
u
Close the lower door.
4.3.12 Fitting the upper door
u
Place the upper door on the middle bearing pin
Fig. 11 (32)
.
u
Insert the upper turn hinge
Fig. 8 (12)
in the door on the new
hinge side.
u
Screw the upper turn hinge firmly into place (with 4 Nm)
(2xTorx® 25)
Fig. 8 (13)
. Possibly make preliminary holes
with a bradawl or use a cordless screwdriver.
u
Snap the cover
Fig. 8 (11)
and cover
Fig. 8 (10)
into place at
the opposite side.
u
Leave the upper door open.
4.3.13 Fitting the upper soft stop mechanism
Fig. 17
u
Remove the cover
Fig. 17 (9)
from the faceplate
Fig. 17 (1)
and re-insert it at the other side.
u
Engage the upper soft stop unit with the joint on the hinge
side (A) and swivel into place (B).
w
The screw holes at the left and right have to register.
u
Screw the soft stop unit firmly into place(2 mal Torx® 15)
Fig. 17 (7)
.
Note
u
Keep to the correct order. First attach the panel over the soft
stop bracket, then the cover.
Putting into operation
* Depending on model and options 9
Loading ...
Loading ...
Loading ...