Loading ...
Loading ...
Loading ...
w
The first time the button is pressed, the previous value is
indicated in the temperature display, upper wine zone
Fig. 3 (8)
or in the temperature display, lower wine zone
Fig. 3 (7)
.
u
To change the temperature in 1 °C steps: briefly press the
button.
-or-
u
To change the temperature continuously: hold down the
button.
w
During setting the new value is displayed flashing.
w
The actual temperature is displayed about 5 s after the last
press of a button. The temperature slowly adjusts to the new
value.
5.6.3 Fan
When the fan runs, the relative humidity in the interior
increases so that the cork does not dry out.
When the fan is activated, the energy consumption increases.
To save energy, the fan switches off automatically when the
door is open.
Switching on the fan
u
Briefly press the fan button
Fig. 3 (17)
.
*
w
The LED of the fan symbol shines.
Switch off the fan
u
Briefly press the fan button
Fig. 3 (17)
.
w
The LED of the fan symbol is dark.
w
The fan runs only when this is necessary for temperature
control. The humidity is low.
5.6.4 Dim mode
For glazed door models you can set the dim mode of the light,
i.e. the intensity with which the light is to shine after the door
has closed.
Setting the dim mode
Note
u
When the dim mode is deactivated, the light becomes
slowly darker after the door has closed and then goes out.
u
Briefly press the Light button
Fig. 3 (16)
.
w
The Light button
Fig. 3 (16)
shines. The dim mode is acti-
vated.
The settings apply to all wine compartments.
u
For a brighter light adjustment: press Light button
Fig. 3 (16)
and Up setting button, wine zone
Fig. 3 (13)
at the same
time.
u
For a darker light adjustment: press Light button
Fig. 3 (16)
and Down setting button, wine zone
Fig. 3 (12)
at the same
time.
5.6.5 Labels
You can note down on the labels the type of wine stored in the
respective compartment. Additional labels can be obtained
from your specialist dealer.
Labelling
5.6.6 Wooden shelf
Pay attention that the wooden
shelf does not get caught on the
rear hook.
u
To remove the folding
wooden shelf: lift it off the
pull-out rail and draw it
forwards.
u
To insert the wooden folding shelf: slide it under the rear
hook and press onto the rails so that they audibly snap into
place.
u
To remove lower wooden
shelf: pull it forwards at an
angle and simultaneously
raise it.
u
To insert lower wooden shelf:
slide it in over the stop on the
intervening shelves up to the
rear wall of the appliance and
press it down.
u
To insert other wooden
shelves: place on the rails.
6 Maintenance
6.1 Replacing the activated charcoal
filter
The activated charcoal filter ensures ideal air quality and
should therefore be replaced annually. It can be ordered from a
specialised dealer.
Each wine zone is equipped with an activated charcoal filter of
its own.
u
Take the activated charcoal filter by
the grip.
u
Turn the activated charcoal filter
through 90° to the right or left
Fig. 24 (1)
.
u
Remove
Fig. 24 (2)
the activated char-
coal filter.
u
Insert the new activated charcoal filter
with the grip in an upright position.
u
Turn the new activated charcoal filter
through 90° to the right or left
Fig. 24 (1)
until it snaps into place.
Fig. 24
6.2 Defrosting with NoFrost
The NoFrost system automatically defrosts the appliance.
Wine zone:
The defrost water evaporates due to the compressor heat.
Drops of water on the rear wall are perfectly normal.
u
Regularly clean the drain opening to allow the water to flow
away (see 6.3) .
u
Clean the rubber lip (see 6.3) .
Freezer compartment:
The moisture condenses on the evaporator, is periodically
defrosted and evaporates.
u
The appliance does not have to be manually defrosted.
Maintenance
* Depending on model and options 15
Loading ...
Loading ...
Loading ...