Loading ...
Loading ...
Loading ...
8239 300 38592
WARNING
Under no circumstances should you try to repair the system yourself, as this will
invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If
you are unable to remedy a problem by following these hints, consult your dealer or
Philips for help.
No power.
No sound or distorted sound.
There is no sound from the center and
rear speakers.
Radio reception is poor.
The remote control does not function
properly.
Low hum or buzz sound.
– Check if the AC power cord is properly
connected.
– Adjust the volume.
– Check the speaker connections and settings.
– Disconnect the headphones.
–Press the correct source button on the
remote (TV or AUX, for example) to choose
the equipment that you want to hear through
the AV receiver.
–Press CENTER +- or REAR +- to
adjust the volume level.
– Make sure the center and rear speakers are
connected correctly.
–Press SURROUND button to select a correct
surround sound setting.
– Make sure the source you are playing is
recorded or broadcast in surround sound
(DTS, Dolby Digital, etc.).
– If the signal is too weak, adjust the antenna or
connect an external antenna for better
reception.
– Increase the distance between the system and
your TV or VCR.
–Tune in to the correct frequency.
– Place the antenna farther away from any
equipment that may be causing the noise.
– Select the source (DISC or TUNER, for
example) before pressing the function button
(S, T).
– Reduce the distance between the remote
control and the system.
– Replace the batteries with new ones.
–Point the remote control directly toward the
IR sensor.
– Check that the batteries are loaded correctly.
– Place the AV receiver as far away as possible
from electrical devices that may be causing
interference.
Problem Solution
Troubleshooting
NEED HELP? Visit our website www.philips.com/ support
23
English
u
s
a
Loading ...
Loading ...
Loading ...