Loading ...
Loading ...
Loading ...
12
SETTING SURFACE CONTROLS
NOTE
See Recommended Setting for Surface Element table on
page 9.
Figure 2 Figure3 Figure 4
Figure 1
CAUTION
Donotplaceplasticitemssuchassaltandpepper
shakers, spoon holders or plastic wrappings on
cooktopwhenitisinuse.These items could melt or
ignite. Potholders, towels or wooden spoons could catch
re if placed too close to the surface elements.
CAUTION
Do not allow aluminum foil, or ANY material that
can melt to make contact with the ceramic glass
cooktop. If these items melt on the cooktop they will
damage the ceramic cooktop.
TRIPLE SURFACE RADIANT ELEMENT
The cooktop is equipped with a triple radiant surface
elements located at the right front position (Figure 1).
Symbols around the knob are used to indicate which
coil of the dual radiant element will heat. The symbol
indicates that only the inner coil will heat (Figure 2). The
symbol indicates that the inner and middle coils will
heat (Figure 3). The symbol indicates that the inner,
middle and outer coils will heat (Figure 4).You may switch
from either coil setting at any time during cooking.
ToOperatetheTripleSurfaceElement
1. Place correctly sized cookware on the triple surface
element.
2. Push in and turn the control knob to the inner coil
symbol for smaller cookware (Figure 2) or to inner and
middle coil symbol for average cookware (Figure 3)
or to inner, middle and outer coil symbol for average
cookware (Figure 4). Turn the knob to adjust the
setting if needed. Start most cooking operations on a
higher setting and then turn to a lower setting to nish
cooking. Each surface element provides a constant
amount of heat at each setting. A glowing red surface
heating area extending beyond the bottom edge of the
cookware indicates the cookware is too small for the
surface heating area.
3. Whencookinghascompleted,turnthesurface
controlknobtoOFFbeforeremovingthe
cookware.
Figure 5 - Control knob shown is typical only.
CAUTION
Radiant surface elements may appear to have
cooled after they have been turned OFF. The
indicator light will turn ON and will
continue to glow until the glass cooktop has cooled
down to a moderate level. The glass surface may
still be hot and burns may occur if the glass surface is
touched before the indicator light has turned OFF. The
indicator light may remain on even though the controls
are turned OFF.
Loading ...
Loading ...
Loading ...