Loading ...
Loading ...
Loading ...
INSTALLATION INSTRUCTIONS
9
Water supply
Inlet hoses
Inlet hose ends
Elbow
(machine) end
Straight
(tap) end
1 Connect the straight ends of the inlet hoses to the taps
(thereare washers fitted in both ends). Connect the red
connector hose to Hot, and the white connector hose
toCold.
2 Connect the elbow ends of the inlet hoses to the
corresponding washer inlet valves. Inlet valves are
marked on the back of the washer. Ensure the Hot
valve is connected to the hot tap and the Cold valve is
connected to the cold tap.
H = Hot C = Cold
Only use the new hose set provided with your washer.
Water supply requirements:
z
If you have an uncontrolled water heating source (eg a wet back or solar heating
system) you should fit a tempering valve. This will ensure the hot water temperature
remains within safe limits. Contact your registered plumber to select and install the
tempering valve.
z
Your cold water should not exceed 35°C and your hot water should not exceed
65°C. Temperatures above these may cause the machine to fault or cause damage
to the machine.
z
Inlet water static pressure: Max.1MPa(145psi) Min.34KPa (5psi).
z
Inlet water flow rate at tap: Min.8litres/min.
Cold water supply only:
If you only have a cold water supply, a blanking cap MUST be connected to the Hot inlet
valve. The cap prevents water leaking out of the hot valve. The cap is available from
your Fisher & Paykel dealer or Fisher & Paykel trained and supported service technician,
PartNo.388491P. This appliance incorporates backflow protection complying with
AS3500.1. No further backflow protection is required for connection to the water supply.
Note: Your washer does not have an internal heater to heat water.
Should you wish to use cold water only for all wash cycles, refer to ‘Customising wash
cycles’ on how to program your washer to remember your wash preferences.
Loading ...
Loading ...
Loading ...