Loading ...
Loading ...
Loading ...
39
CHANGING PRE-SET OPTIONS
Out of balance recovery routine
When your washer is spinning it can sense if the wash load is out of balance. If an out of
balance load is detected, the washer will stop and re-try spinning up to three times. If it still
senses an unbalanced load there are two options the washer can take.
Automatic recovery option
Your washer will try to automatically correct the out of balance load. It will fill with water
and agitate to redistribute the load before trying to spin up again.
Washer stops option
Your washer will stop, give a short burst of beeps every five seconds, and the
RINSE or SPIN
light will flash. You must redistribute the load more evenly yourself (use this option if you
wish to conserve water).
Enter Option Adjustment mode. and use the table below to select your preferred recovery
option.
WashSmart™ QuickSmart™
‘Regular’
light on =
automatic
recovery
‘Regular’
light off =
washer stops
‘Regular’
light on =
automatic
recovery
‘Regular’
light off =
washer stops
Adjusting the out of balance recovery routine
Loading ...
Loading ...
Loading ...