Loading ...
Loading ...
Loading ...
43
BEFORE YOU CALL FOR SERVICE
User warnings
Your washer is capable of self diagnosis and may sound a series of beeps and display
anotification or warning to inform you when there is aproblem. In most cases you will be
able to address the problem the washer is alerting you to. Check this chart before you call
for service.
PROBLEM DISPLAYED AS WHAT TO DO
The washer is
not getting any
hot water.
HOT water
temperature light
flashing.
Hot water supply is not hot enough to maintain the wash
temperature you have selected.
Select a lower wash temperature.
Inlet hose filters may be blocked and should be cleaned
or replaced.
There may be a kink in the hose, undo the hose to remove the
kink, and reattach. Damaged hoses should be replaced.
Ensure the hot tap has been turned on.
Check the inlet hoses are connected to the correct taps.
The washer is
not getting any
cold water.
COLD water
temperature light
flashing.
Ensure cold tap has been turned on.
Inlet hose filters may be blocked and should be cleaned
or replaced.
There may be a kink in the hose, undo the hose to remove the
kink, and reattach. Damaged hoses should be replaced.
Check the inlet hoses are connected to the correct taps.
Cold water temperature exceeds recommended limits, refer to
‘Installation instructions’.
The flow rate of the supply water is too slow. Refer to a
registered plumber for advice.
The washer is
not getting any
water.
HOT and COLD
temperature light
flashing.
Ensure the taps have been turned on.
Inlet hose filters may be blocked and should be cleaned
or replaced.
There may be a kink in the hose, undo the hose to remove the
kink, and reattach. Damaged hoses should be replaced.
The drain hose is too low or the drain hose is pushed into the
standpipe too far and the water is siphoning out of the washer,
refer to ‘Installation instructions’.
The flow rate of the supply water is too slow. Refer to a
registered plumber for advice.
Loading ...
Loading ...
Loading ...