Loading ...
Loading ...
Loading ...
21
6. Press the
icon (g. 6);
7. The message “Conrm?” is now displayed;
8. Press the icon to conrm the selection;
9. “HOT WATER Press OK” is displayed;
10. Press the
icon to conrm the selection. The appliance
begins hot water delivery and the message “Please wait” is
displayed;
11. After the ow of hot water stops, the appliance automatically
resets to “Ready for coee” status.
The new lter is now active and you can use the coee machine.
Removing the lter
If you want to use the appliance without the lter, you must
remove it and notify the appliance of its removal. Proceed as
follows:
1. Remove the tank, remove the lter and put the tank back
in the appliance;
2. Press the
(B2) icon to enter the menu;
3. Press
or (g. 5) until “Install lter Enable” is
displayed;
4. Press the icon (g. 6);
5. “Disable?” is displayed;
6. Press the
icon to conrm and the
icon to exit
the menu.
TECHNICAL DATA
Voltage: 220-240 V~ 50/60 Hz max. 10A
Absorbed power: 1450W
Pressure: 1,5MPa (15 bar)
Max. water tank capacity: 1,4 l
Size: LxDxH: 195x480x340 mm
Cord length: 1660 mm
Weight: 9,7 kg
Max. beans container capacity: 150 g
The appliance complies with the following EC
directives:
• Low Voltage Directive 2006/95/EC and subsequent
amendments;
• EMC Directive 2004/108/EC and subsequent amendments;
• European Standby Regulation 1275/2008
• Materials and accessories coming into contact with food
conform to EEC regulation 1935/2004.
DISPOSAL
In compliance with European directive 2002/96/EC,
the appliance must not be disposed of with house-
hold waste, but taken to an authorised waste separa-
tion and recycling centre.
DISPLAYED MESSAGES
DISPLAYED MESSAGE POSSIBLE CAUSE SOLUTION
FILL TANK Insucien
t water in the tank (A18). Fill the tank with water and/or insert it cor-
rectly, pushing it as far as it will go until it
clicks into place.
EMPTY GROUNDS CONTAINER The grounds container (A13) is full.
Empty the grounds container and drip tray,
clean and replace. Important: when removing
the drip tray, the grounds container MUST be
emptied, even if it contains few grounds. If this
is not done, when you make the next coees,
the grounds container may ll up more than
expected and clog the machine.
INSERADD PREGROUND
COFFEE
After cleaning, the grounds container has not
been replaced (A13).
Remove the drip tray and insert the grounds
container.
ADD PRE-GROUND COFFEE With the “pre-ground coee” function selected,
pre-ground coee has not been poured into the
funnel (A4).
Place pre-ground coee in the funnel or dese-
lect the “pre-ground” function (g. 16).
Loading ...
Loading ...
Loading ...