Loading ...
Loading ...
Loading ...
12 13
Notes for Moving and
Transporting
•
Remove all food from inside the appliance. Then,
transport the appliance only after xing fragile
parts such as shelves and the door handle with
tape. Failure to do so may cause appliance
damage.
•
Pull the power plug out, insert and x it into the
power plug hook at the rear or on top of the
appliance. Failure to do so may cause damage to
the power plug or oor scratch.
•
When transporting the appliance, more than two
people should transport the appliance carefully.
Dropping the appliance, which is extremely
heavy, may cause personal injury or appliance
failure.
•
When transporting the appliance over a long
distance, keep the appliance upright. The
appliance may fall over, causing malfunctions.
Never transport the appliance laying down as it
can cause a refrigerant circulation malfunction
when it is turned back on again.
Notes for Installation
•
Install the appliance on a solid and at area.
–
If the appliance is installed on an uneven oor,
it can cause vibration and noise causing the
appliance to fall resulting in injury. It could
also cause the doors not to close correctly
and introduce moisture inside the unit during
operation.
–
If the appliance front or rear is not level, adjust
the front feet so that it can be corrected.
Severe cases may need the oor to be packed
out with strips of thin timber.
•
Avoid placing the unit near heat sources, direct
sunlight or moisture.
•
Connect the power supply cord (or plug) to the
outlet. Don't double up with other appliances on
the same outlet.
•
After connecting the power supply cord (or plug)
to the outlet, Wait two or three hours before
you put food into the appliance. If you add food
before the appliance has cooled completely, your
food may spoil.
•
Models with handles should be located at least
55 mm from the wall on the hinge side to open
door by 90°.
•
Allow over 55 mm clearance to the right, left,
back and top when installing.
Removing the Door
When it is necessary to move the appliance
through a narrow opening, removing the doors is
the recommended procedure.
WARNING
•
Disconnect the power cord, house fuse or circuit
breaker before installing or service the appliance.
Failure to follow these instructions may result in
death, re or electric shock.
If your entrance door is too narrow for the
appliance to pass through, remove the appliance
doors and pass the appliance laterally.
[For both freezer and fridge]
1
Remove the screw of the hinge cover
on top of the appliance by rotating it
counterclockwise.
2
While pressing
①
hook of the link of the
electrical connectors, remove the link by
pulling it in both directions.
1
3
Remove the hinge lever by tapping the end of
it toward the outside edge of the cabinet.
CAUTION
•
When removing the upper hinge, be sure to
support the door as it will fall forwards. It is
recommended that 2 people carry out the door
removal and retting.
4
Lift the upper hinge xed between the
appliance and the appliance door and then
remove it.
Upper hinge
Door
5
Remove the freezer and fridge compartment
door by lifting it upward.
Retting the Door
Mount them in the reverse sequence of removal
after the appliance is passed through the access
door.
Loading ...
Loading ...
Loading ...