Loading ...
Loading ...
Loading ...
/
Fig. ?B
H_NGE
STOP POSITION
3"O remove:
1. Open the door to the stop position (see fl}ustlation).
2_ Grasp the door at each side and lift up and off the
hinges. DO NOT lift door by the handle; door glass
breakage or damage to the door could resuIL
NOTE: When the door is removed and hinge arms are at
stop position, do not bump or try to move the hinge
arms. The hinges could snap back causing an injury to
the hands or damage to the porcelain on the front of the
range. Cover the hinges with toweling or empty towel
roils while working tn the oven area°
To reptace:
1_ Hold the door over the hinges with the slots at the
bottom edge of the door lined up with the hinges.
The hinge arms must still be tn the stop position.
2. Slide the door down onto the hinges as far as it will
go and close the door.
2 Push the rack inun!ilyou reach the bump in the rack
guide, then Itlt the lront of _he rack a bit and push lt_a
rack all the way in
To remove:
Pull the oven rack out, the_ up, in one motion, See
the cleaning chart,
NOTE:
(A) The racks are designed with stop locks,
When placed correctly on the rack support and
extended from the oven, the stop lock prevents
lhe racks from tilting when you are removing
food from the racks or placing food on them,
(B) For best performance, remove oven racks
during selFclean cycle_ If oven racks are _eftin
the range during aclean cycle, they will darken,
lose theil luster and become hard to slide. Ii
you choose to leave the racks in the oven, you
can polish the edges of the racks with steel
wool and apply a small amount of vegetable oil
to the rack edges after the self-clean cycle.
This will make the racks easier to slide.
R PLACING L GHT
BULB
NOTE: Do not allow water to run down inside the door,
Open door completely whencleaning thetop edge.
RE ' OVABILA OVAN IRACi $
BULB COVER BAIL WIRE
Do not touch hot oven bulb, Do not
touch buJb w_h wet hands, Never
wipe oven light area wi_h wet cloth.
Never touch _he electrically live metal
coRlar on _he buib when replacing,
BUMP
IN RACK
GUIDE
Be careful not to scratch the oven finish when installing
or removing oven racks.
To instail:
1. Set the raised back edge ofthe rack on a pair of rack
guide&
15
To remove:
1_ Disconnect electric power to the oven at the main
fuse or circuit breaker°
2o Hold your hand under cover and firmly push back the
bait wire until it clears the cover. The cover will fall
into your hand. DO NOT REMOVE ANY SCREWS
TO RE_v_OVE THE COVER.
3, Replace bulb with 40-watt home appliance bulb,
To replace covert
!o Place cover into groove of tamp receptacle, Pullwire
bail forward until it snaps into place. Be certain wire
bail is in center of cover, Wire will hold cover firmly
when in correct position.
2, Connect power to oven,
NEMNT127
Loading ...
Loading ...
Loading ...