Loading ...
Loading ...
Loading ...
802258 - B, BA, BHA, BAHA, - HydroTap User Guide - July 2015- V2.00 Page 21 of 24
Dispense Times
The ability to change the maximum
dispensing time for both the Hot and
Ambient water has been introduced.
The default settings for the maximum
dispensing times is 15 seconds. Here,
the operator may change both the
Hot and Ambient dispensing times
to between 5 and 15 seconds, in
increments of 1 second. To edit the
dispensing times:
1.
Press the [MENU] button for main
menu.
2.
Press the [Setting] button.
3.
Press the [Dispense Time] button.
4.
Select the option to change and
scroll using the up and down arrow
Keys
The Zip HydroTap notifies when filter replacement is due. If you notice one of
the following, you will need to change the filter:
•
The Change Filter light will flash white once a second and remain so until
reset. A filter status light is located below the Chilled Blue Lights on the tap
head assembly.
•
The filter percentage will change to 0% on the screen.
Note:
Depending on local water quality conditions and usage, the filter
may require changing anywhere from 500 Ltrs to 10000 Ltrs. You may also
need to replace the filter if you notice unpleasant odours or tastes.
Some water may drip from the filter
head (socket) during replacement.
Keep a towel handy to dry up any
drips.
Water Filter
To Activate Hot Isolation:
•
Press button - to Enable / Disable Hot isolation.
•
To operate the tap when in Hot Isolation mode, tap the Safety Lock (3)
three times, after a few seconds the tap lights will flash (3) three times.
This confirms de-activation and allows Boiling water to be dispensed . The
Hot Isolation can be immediately set again, by tapping the safety lock (3)
times.
•
If the Hot Isolation is not re-enabled, it will be automatically re-enabled
after 30 seconds of inactivity.
LCD Screen operation - Section G
C
Filter Maintenance
Loading ...
Loading ...
Loading ...