Loading ...
Loading ...
Loading ...
14-5
14-5. Q & A
NO. Question Answer
1 How long does it take for the door to unlock? It takes approximately 2-3 seconds for the door to unlock.
2
The cycle is complete and “End” is displayed.
How do I set another cycle?
When “End” is displayed, the Power button should be pressed or door
should be opened before selecting another cycle. The display will show
“End” until washer is turned off. To turn off washer, the Power button
should be pressed or the door should be opened
3
What should I do when Information Code
(“dc”) lights up?
When the Information Code is displayed, press the Start/Pause dial
and then restart the cycle. For more information, refer to the Owner’s
Manual
4
There is a small amount of water left in
Detergent Drawer after the load is complete.
Is this normal?
It is normal for a small amount of water remaining in Detergent Drawer
after it completes washing. Bleach is usually flushed out into the tub at
the beginning of the washing. Also, its compartment is washed again
during the following rinse cycle, removing any remnants.
5
When I went back to my washer, it was turned
off. What happened?
Power button may have been accidentally bumped or pushed. Reset
the cycle and start the washer. Make sure the unit is plugged into a live
electrical outlet. Check house fuse or circuit breaker.
6
The washer door gets locked after a power
failure. How can I open it?
If the power fails while the door is locked, the door will remain locked
until the power comes back on. If the power comes back on while the
door is still locked, the cycle will resume where it left off. If the door is
unlocked, “PF” will display and the washer will pause. Press Power Off
and restart the cycle.
7
The washer door does not unlock when there
is water in the tub. How can I open it?
The water must be drained from the tub for the door to be opened. Set
the rotary dial to Spin Only and press the Start/Pause dial. The door will
open 2-3 seconds after the Spin or Drain cycle is completed.
Loading ...
Loading ...