Loading ...
Loading ...
Loading ...
24 Rev 0.0
USER INSTRUCTIONS
EN
FAULT DESCRIPTION
E6
AUTO
Water pump-out malfunction
The appliance does not pump out the water or does so
incorrectly. Make sure the drain hose is not kinked or
crushed and that the siphon and fi lters are not clogged.
If the problem persists, contact the technical assistance
center.
E7
AUTO
Turbine fl ow-regulator malfunction
The appliance is unable to precisely measure the
quantity of incoming water. Interrupt the current program
and switch off the dishwasher. Switch it back on again,
program a new cycle and press start. If the problem
persists, contact the technical assistance center.
E8
AUTO
Alternate washing system malfunction
Interrupt the current program and switch off the
dishwasher. Switch it back on again, program a new
cycle and press start. If the problem persists, contact
the technical assistance center.
E9
AUTO
Water intake system malfunction
Contact the technical assistance center.
Table 6-01b
Light off Light on Light fl ashing
If an alarm situation occurs, the dishwasher interrupts the current program and
signals the fault.
Alarms • E1, E2, E3, E4, E8, E9 immediately terminate the current program.
Alarms• E5, E6 interrupt the current program and, after the problem has been
eliminated, resume the cycle.
Alarm • E7 is displayed at the end of the cycle which, however, is completed
given that it does not jeopardize the operation of the dishwasher.
To “reset” an alarm:
open or close the door, or switch the appliance on and back off again. At this •
point, the dishwasher can be programmed again.
If the fault persists, contact the Authorized Technical Assistance
Center.
Loading ...
Loading ...
Loading ...