Loading ...
Loading ...
Loading ...
14 INSTALLATION
Reversing Doors
This feature is only available on some models.
Your appliance is designed with reversible
doors, so that they may open from either the left
of right hand side to suit your kitchen design.
NOTE
• Door reversal must be done by qualified LG
Electronics personnel. If it is not, the doors will
not be covered by the warranty.
Leveling and Door Alignment
Leveling
The refrigerator has two front leveling legs.
Adjust the legs to alter the tilt from front-to-
back or side-to side. If the refrigerator seems
unsteady, or the doors do not close easily,
adjust the refrigerator’s tilt using the instructions
below:
1
Turn the leveling leg to the left to raise that
side of the refrigerator or to the right to lower
it. It may take several turns of the leveling
leg to adjust the tilt of the refrigerator.
NOTE
• A flare nut wrench works best, but an open-
end wrench will suffice. Do not over-tighten.
2
Open both doors and check to make sure
that they close easily. If the doors do not
close easily, tilt the refrigerator slightly more
to the rear by turning both leveling legs to
the left. It may take several more turns, and
be sure to turn both leveling legs the same
amount.
Door Alignment
The refrigerator doors have an adjustable nut,
located on the bottom hinge, to raise and lower
them to align properly.
If the space between the doors is uneven after
the door bins are filled, follow the instructions
below to align the doors evenly.
Use the wrench to turn the nut in the door hinge
to adjust the height. Turn the nut to the right to
raise the door or to the left to lower it.
Turning on the Power
• After installing, plug the refrigerator’s power
cord into a 3-prong grounded outlet and push
the refrigerator into the final position.
CAUTION
• Connect to a rated power outlet.
• Have a certified electrician check the wall
outlet and wiring for proper grounding.
• Do not damage or cut off the ground
terminal of the power plug.
Position the Refrigerator
• Arrange the coil of tubing so that it does not
vibrate against the back of the refrigerator or
against the wall. Push the refrigerator back to
the wall.
Loading ...
Loading ...
Loading ...