Loading ...
Loading ...
Loading ...
Faults and what to do about them en
47
Information on the display panel
Display Cause/Remedy
Õ Flashes fast + signal: The door was opened and the water level is too high.
Close the door, continue the programme with A button or select Spin pro-
gramme.
Flashes slowly: The door lock temperature is too high to open the door. Wait
approx. 30 seconds until the door lock temperature cools down.
Hot The door cannot be opened after the drying programme due to the high tempera-
ture. The cooling process continues until the display disappears, after which the
door can be opened.
r Flashes (no water supply): Water tap turned on? Filter in the water supply is
blocked?
~ "Filter in the water supply is blocked" on page 45
Is the supply hose kinked or trapped?
Lights up (low water pressure): For information only. This will not affect the
programme progress. The programme duration is extended.
E:36
alternating with
-10 and End
when programme is
finished
The drain pump is blocked.
~ "Drain pump is blocked" on page 43
The drain hose at the siphon is blocked.
~ "The drain hose at the siphon is blocked" on page 44
H:95
alternating with
End
when programme is
finished
No water detected in drying phase, may get bad drying result.
H:32
alternating with
End
when programme is
finished
Unbalance problem, spinning phase is aborted.
E (3s) lights up The childproof lock is activated – deactivate it.
Å lights up Too much foam has been detected and an additional wash cycle has been acti-
vated. Add less detergent to the next washing cycle with the same load.
The indicator lamp of
the Drum Clean pro-
gramme flashes
Run the Drum Clean 90°C programme to clean and care for the drum and the
outer tub.
Notes
Run the programme without laundry.
Use washing powder or a detergent containing bleach. To prevent foaming,
only use half the amount of detergent recommended by the detergent manu-
facturer. Do not use detergent designed for woollens or delicates.
Switching the Drum Clean information signal on/off.
~ "Switching the drum-care information signal on/off" on page 41
Other displays Switch off the appliance, wait for five seconds and then switch it on again. If the dis-
play appears again, call customer service.
Loading ...
Loading ...
Loading ...