Loading ...
Loading ...
Loading ...
47
Option
Terminal
Power management
Power management
The RGB IN 2/RGB OUT terminal on the back of the projector is switchable for computer input or monitor
output(See page 13). Select RGB2 or RGB Out with ▲▼ buttons.
RGB2 ..........RGB2 Input.
RGB Out ......RGB output.
RGB Out is the same signal as RGB IN 1.
For reducing power consumption as well as maintaining the lamp life, the Power management function
turns off the projection lamp when the projector is not operated for a certain period.
Select one of the following options:
Ready ..................When the lamp has been fully cooled down, the POWER/TEMP indicator changes
to green blinking.In this condition, the projection lamp will be turned on if the input
signal is reconnected or any button on the top control or remote control is pressed.
Shut down .......... When the lamp has been fully cooled down, the power will be shut down.
Off ....................... Power management function is off.
Timer ................... If the input signal is interrupted and no button is pressed for more than 30 seconds,
the timer display with No signal appears. It starts the countdown until the lamp is
turned off. Press ▲▼ buttons to set the Timer(1~30min.)
√ Note:
Factory default is Ready: 5 Min.
Auto Power
This function enables projector auto power on with detection connection with AC power cord.
On ....................... Auto Power function is On.
Off ....................... Auto Power function is Off.
No signal
01 : 20
Time left before Lamp is off.
Standby mode
There are two standby modes in the projector.
Normal ...... in this mode, RS-232C and RGB Out functions can be used.
Eco ............ Low power standby mode, in this mode, RS-232C and RGB Out functions can not be
used.
Loading ...
Loading ...
Loading ...