Reassigning the DVD•VCR Key to Control a VCR section.
previous ten codes.
To exit without saving a new code at any point in the Brand
Did your device turn on?
Code Search, press the EXIT key.
YES: Press the STOP key. You’re done! You’ve programmed this device key.
Newest Added: Nokia 3.1 NS-RMTSNY17 10.1”, NS-RMTEXB17 XE521QAB-K01US
1. Manually turn on the device you
want to control. NO: Press REVERSE again. The remote tests the next code in the batch. Keep pressing REVERSE every 2 seconds until your device turns back on. When it does, press STOP. Note: If you accidentally press the REVERSE key after your device turns on, press the FORWARD key. Then, wait two seconds to see if your device turns off again.
Throughout the programming of each key, be sure to keep the remote pointed at the IR sensor of the device you are currently programming the remote to control.
3. Press and hold the device key you want to program. The
Test the remote with the device to make sure the
POWER key illuminates.
device key is programmed with the correct code for
While you’re holding down the device key, use your other maximum functionality. If some features don’t work, try
hand to press and hold the remote’s POWER key at the a different code. See the “Testing the Code for Maximum
same time. The POWER key turns off. Functionality” section below for more information.
During the Auto Code Search, the remote ignores keypresses that aren’t part of the search.
The search times out after two minutes (the POWER key blinks four times and turns off, and the last programmed code under that device key is retained).
The POWER key blinks four times and turns off when the remote has gone through all the codes. The remote exits the Auto Code Search. If your device hasn’t turned off yet,
2. Find the Code List that came with the remote. Locate the section for the type of device you’re trying to program, and find your brand in that section. Circle the codes for your brand and keep them handy. 4. Wait until the POWER key comes