Loading ...
Loading ...
Loading ...
37
CONTROL AND PARTS FUNCTIONS
With engine running, verify function of indicator lights each time ATV is used.
W ARNING
This ATV is not equipped with highway approved lighting. This ATV is designed
for off-road use only and must not be ridden on streets or highways. Use caution
and drive at reduced speeds in conditions ofreduced visibility such as fog, rain and
darkness.
NOTE: The taillight is on wheneverthe mainswitch (key)is inthe on position. Turn
the k ey off to prevent battery drain.
indicates a potential hazard which
couldresult in serious injury ordeath.
WARNING
Electronic Speedometer
Some Polaris ATVs are equipped with an electronic speedometer which senses
vehicle speed from the right hand front wheel. The electronic speedometer mea-
sures distance in miles and kilometers as well as hours of operation. To display
each mode, press the button on the face of the speedometer once to “toggle”
through the functions. Each function will be displayed as follows:
Miles 00000.0 M
Trip Miles 000.0 M
Hours 00000.0 H
To reset Trip Miles:
1.Toggle to Trip Miles
2.Hold down button approximately 4 seconds.
To change distance measurement from Miles to Kilometers or vice versa:
1.Toggle to odometer.
2.Hold down the button approximately 8 seconds until the word FARIA appears
in the display, then release the button. If the last digit in the display is a “K”, the
measurement is Kilometers,ifthe last digit is an“M”, themeasurement is Miles.
The speedometer also includes a reverse speed limitfunction thatlimits the ATV’s
speed in reverse after approximately 7 to 9 mph. Refer to page 35 for additional
information.
ATTENTION
Do not wash the electronic speedometer with a high pressure washer.
Wash the unit by hand or with a garden hose. High water pressure
may allow water to enter the speedometer and cause damage to the
electronic components
Loading ...
Loading ...
Loading ...