Loading ...
Loading ...
Loading ...
116
MAINTENANCE
Headlight Replacement (cont.)
9.Carefully unplug the socket from the lamp. Remove the panel and set it aside.
10.Stand the panel containing the headlight assembly on end to allow access to
the back of the headlight assembly.
11.Remove bolt and disengage the wire bail holding the headlight lamp in place
and move it out of the way.
12.Grasp the base of the lamp and lift it out.
13.Reverse the previous steps to replace the lamp and reassemble the panels.
High Beam Headlight Adjustment
The headlight beam can be adjusted to any position desired by turning the four
screws at the outer corners of the lamp housing.
1.Place the vehicle on a level surface with the headlight approximately 25’ (7.6
m) from a wall.
2.Measure the distance from the floor to the center of the headlight and make a
mark on the wall at the same height.
3.Start the engine and turn the headlight switch to high beam.
4.Observ e headlight aim. The most intense part of the headlight beam should
be aimed 2 ″ (5.1cm) belowthe mark placed on the wallin step 2. NOTE: Rider
weight must be included on the seat.
5.Adjust beam to desired position by turning screws on the housing.
Loading ...
Loading ...
Loading ...