Loading ...
Loading ...
Loading ...
113
MAINTENANCE
Headlight Lamp Replacement
WARNING: Due to the nature of ATVs and where they are ridden, headlight
and taillight lenses become dirty. Frequent washing is necessary to maintain light-
ing quality. Poor lighting while riding can result in severe injury or death.
CAUTION: Do not service while headlight is hot. Serious burns may result.
NOTE: Do not touch a halogen lamp with bare fingers. Oil from your skin leaves
a residue, causing a hot spot which will shorten the life of the lamp.
Headlight Lamp Replacement - Scrambler
1.Remove wire harness connector from the back of headlight.
2.Grasp bulb housing, turn counterclockwise and remove bulb.
3.Install bulb into headlight housing and rotate clockwise firmly. NOTE: Bulb is
to be positioned so the harness installs into the lamp at the bottom.
4.Reinstall connector.
High Beam Headlight Adjustment
The headlight beam can be adjusted up and down.
1.Place the vehicle on a level surface with the headlight approximately 25’ (7.6 m)
from a wall.
2.Measure the distance from the floor to the center of the headlight and make a
mark on the wall at the same height.
3.Start the engine and turn the headlight switch to high beam.
4.Observ e headlight aim. The most intense part of the headlight beam should be
aimed 2″ (5.1 cm) below the mark placed on the wall in step 2. NOTE: Rider
weight must be included on the seat.
5.Loosen pivot bolt and adjust beam to desired position.
6.Tighten nut and bolt. Torque to 60 in. lbs.
Loading ...
Loading ...
Loading ...