Loading ...
Loading ...
Loading ...
Installation and connection en
43
1. Plug into the mains.
2. Turn the tap on.
3. Switch on the appliance.
4. Close the door. Do not load any
laundry.
5. Select the
Fluff Clean l 40°C
programme.
6. Open the detergent drawer.
7. Pour approx. 1 litre of water into
dispenser
II.
8. Add standard detergent to
dispenser
II according
to manufacturer’s instructions for
light soiling.
Note: To prevent frothing, use only
half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
9. Close the detergent drawer.
10.Select
Start/Reload A.
11.When the programme ends, switch
off the appliance.
Your washer dryer is now ready for use.
Transportation
Preparatory work
1. Turn off the tap.
2. Release the water pressure in the
supply hose.
Filter in the water inlet hose blocked
~ Page 29
3. Drain any residual washing water.
Drain pump blocked ~ Page 28
4. Disconnect the washer dryer from
the power supply.
5. Remove the hoses.
Installing transportation protection
devices:
1. Remove the covers and keep in a
safe place.
If required, use a screwdriver.
2. Insert all 4 sleeves.
Clamp the mains cable on the
holders. Insert and tighten the bolts.
Before switching on the appliance:
Notes
■ Always remove the transportation
protection devices!
■ To prevent unused detergent from
flowing into the outlet during the next
wash: Pour 1 litre of water into
dispenser
II and start the Spin 0 or
Drain
[ programme.
Loading ...