Loading ...
Loading ...
Loading ...
Faults and what to do about them en
31
Information on the display
panel
Display Cause/Remedy
A:01 Close the door immediately because of the rising water level. If an interruption
occurs, A:01 and OPEN are displayed alternately.
A:02 The door is locked for safety reasons (water level and/or temperature too high).
■ Washing programme: In top-up mode A:02 and PAUS are displayed alter-
nately. If you have to open the door, wait until the temperature has dropped
slightly or pump out the water (select e.g. Spin 0 or Drain
[).
■ Drying programme: If you have to open the door, wait until the tempera-
ture has dropped slightly or set the drying programme to 15 min to cool
down the laundry.
If A:02 is frequently displayed at the end of the drying programme:
■ Clean the air filter. ~ Page 30
■ Run the Fluff Clean l Ž (cold) programme without laundry.
A:03 Door cannot be locked/unlocked due to high temperature. Leave the washer
dryer switched on for about 1 min. The washer dryer can then be locked/
unlocked again.
hot The door cannot be opened after the drying programme due to the high temper-
ature. The cooling process continues until the display disappears, after which
the door can be opened.
¹ ■ Flashes (no water supply): Tap turned on? Water inlet filter blocked?
Clean the water inlet filter. ~ Page 29
Water hose kinked or blocked?
■ Iights up (low water pressure): For information only. This will not affect the
programme progress. The programme duration is extended.
E:18 Drain pump blocked; clean the drain pump. Clean the drainage hose
on the siphon.
ªªª ■ Hold down button 5 (Drying) for 3 seconds to delete the display.
■ Clean the air filter. ~ Page 30
■ Run the Fluff Clean l Ž (cold) programme without laundry.
LO kg, HI kg Laundry amount information. On when drying phase finished.
LO kg: Signals a small load for drying,
HI kg: Signals a very high load for drying.
Other displays Turn the programme selector to Ú Off. The appliance is switched off. Wait 5 s
and switch on again. If the display is indicated again, call customer service.
Loading ...
Loading ...
Loading ...