Loading ...
Loading ...
Loading ...
Faults and what to do about them en
33
Display panel/indicator
lights do not function
while the appliance is run-
ning.
■ Power failure?
■ Fuse tripped? Switch on/replace fuse.
■ If the fault occurs repeatedly, call customer service. ~ Page 35
The programme duration
changes during the wash
cycle.
■ Not a fault – unbalanced load detection system adjusts imbalance.
■ Not a fault – foam detection function active. Additional rinse cycle.
Detergent residue on the
washing.
■ Occasionally phosphate-free detergents contain water-insoluble residue.
■ Select Rinse à or brush items when the laundry is dry.
Spin noise during the dry-
ing phase.
This is an innovative process known as thermal spinning used to reduce
energy consumption during the drying phase.
Different coloured fluff
from the previous drying
cycle is deposited on the
laundry during the subse-
quent wash cycle.
Run the Fluff Clean l Ž (cold) programme without laundry to remove fluff
which has collected in the washer drum during the drying phase.
Water inlet noise during
the drying phase, the tap
symbol flashes during the
drying phase.
The washer dryer runs a self-cleaning cycle to remove fluff which was depos-
ited by the laundry during the drying phase. This requires a little water. There-
fore, the tap must be turned on even during the drying phase.
Drying duration extended. ■ According to the air cooling principle, a higher ambient temperature will
result in poor drying performance, so the drying time will be extended.
Ensure good ventilation to allow surplus heat to escape.
■ Air filter blocked? Clean the air filter ~ Page 30
■ Run the Fluff Clean l Ž (cold) programme to remove fluff which has col-
lected in the washer drum during the drying phase.
Drying programme does
not start.
■ Drying programme not selected? Overview of programmes~ Page 20
■ Door not closed properly?
■ Pump blocked? Clean the drain pump.~ Page 28
Faults Cause/Remedy
Loading ...
Loading ...
Loading ...