Loading ...
Loading ...
Loading ...
Cleaning and maintenance en
29
2. Turn the programme selector to
Ú Off. Pull out the mains plug.
3. Open the service flap.
4. Take the drainage hose out of the
holder.
5. Remove the cover flap, draining the
washing water into a suitable
container. Press on the cover flap
and insert the drainage hose into the
holder.
Note: Residual water may run out.
6. Carefully unscrew the pump cover.
Clean the interior, pump cover
thread and pump housing (the fan
impeller in the detergent-solution
pump must be able to rotate).
7. Reinsert and screw on the pump
cover. Handle should be vertical.
8. Close the service flap. If required,
engage the disengaged service flap
beforehand.
Note: To prevent unused detergent from
flowing into the outlet during the next
wash: Pour 1 litre of water into
dispenser
II and start the Spin 0 or
Drain [.
Drainage hose on the siphon
blocked
1. Turn the programme selector to
Ú
Off. Pull out the mains plug.
2. Loosen hose clip, carefully remove
drainage hose. Residual water may
run out.
3. Clean drainage hose and siphon
spigot.
4. Re-attach the drainage hose and
secure the connection point with the
hose clip.
Filter in the water inlet hose
blocked
:Warning
Danger of death!
Do not immerse the Aqua-Stop safety
device in water (it contains an electric
valve).
First, reduce the water pressure in the
supply hose:
1. Turn off the tap.
2. Select any programme (except
Spin 0 or Drain [).
3. Select
Start/Reload A. Allow the
programme to run for approx. 40 s.
4. Turn the programme selector to
Ú Off. Pull out the mains plug.
5. Clean the filter on the tap:
Disconnect the hose from the water
tap.
Clean the filter with a small brush.
6. Clean the filter on the back of the
appliance:
Loading ...
Loading ...
Loading ...