Loading ...
Loading ...
Loading ...
Page 30 User Manual
Operating
Instructions
(With Remote)
Energy saver operation
In this mode, the fan will continue to run for 3 minutes after the
compressor shuts off. The fan then cycles on for 2 minutes at 10
minute intervals until the room temperature is above the set
temperature, at which time the compressor turns back on and
cooling resumes.
1
NOTE
• Button design is based on a typical model and may slightly vary from the actual one you purchased.
• All the functions described can also be accomplished using the unit’s control panel. If the unit is
without this feature, there will be no corresponding operation when pressing the relevant button
on the remote controller.
• When there are significant differences between features or operation implied by the remote
control illustration and the actual functions described in the USER’S MANUAL, the descriptions
in the USER’S MANUAL shall prevail.
• The device may comply with local national regulations. In Canada, it should comply with CAN
ICES-3(B)/NMB-3(B). In USA, this device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may
cause undesired operation.
• This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit di erent from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
- Changes or modi cations not approved by the party responsible for compliance could void
users authority to operate the equipment.
Loading ...
Loading ...