Loading ...
Loading ...
Loading ...
User Manual Page 19
Installation
Instructions
1 Select Wall Location
The air conditioner has a slide-out chassis, so that it can be installed through an outside wall as
speci ed below:
Max. Wall thickness: 12” or 10”
IMPORTANT: Side louvers must never be blocked.
NOTE
Consult local building codes prior to Installation, or a qualified carpenter.
NOTE
All parts needed for Thru-The-Wall Installtion are provided, except a wood frame, shims, and 10 wood
screws (#10-1” long minimum).
Select a wall surface that:
1. Does not support major structural loads such as the frame construction at ends of windows, under
truss-bearing points, etc.
2. Does not have plumbing or wiring inside.
3. Is near existing electrical outlets, or where another outlet can be installed.
4. Faces, and is not cut o from the area to be cooled.
5. Allows unblocked air ow from rear sides and end (outside) of installed air conditioner.
B. Thru-the Wall Installation
2 Prepare Wall
1. Prepare wall in frame construction (including brick and stucco
veneer). Working from inside the room, locate wall stud nearest
the center of area where air conditioner will be installed.
2. Cut or knock out a hole on each side of center stud.
3. Measure between inside edges of every other stud as shown
in Fig. 25.
3-3/8" MIN
(8.6 cm)
Fig. 25
Fig. 25A
Up to 8-1/2"
Inside
Frame
Height
Y
X
Inside
Frame
Widht
Carefully measure and cut an opening with the following dimensions
depending on your model.
See Fig. 25 and Fig. 25A.
WIDTH X = inside model width plus twice the thickness of framing
material used.
HEIGHT Y = inside model height plus twice the thickness of framing
material used.
Inside Frame Height: 18-7/8” (47.9 cm) or 18” (45.7 cm)
Inside Frame Width: 26-3/4” (67.9 cm) or 23-7/8” (60.6 cm)
Loading ...
Loading ...
Loading ...