Loading ...
Loading ...
Loading ...
Place wires inside terminal box. Replace the cover by inserting
the hooks of the terminal cover into the slots in the floor of the
terminal box and sliding the cover tight against the back walE
where wires come in. Make sure wires are tucked inside the box
and not pinched by the cover.
Then, put the terminal box back on the crossbar with the tab in
place. Use a 1/4"nut driver and the previously removed screw to
secure the terminal box to the crossbar.
NOTE= Do not plug into outlet until instructed to do so.
Once the terminal box has been remounted on the dishwasher,
there should be some excess length or slack in the green, black,
and white wires coming from the dishwasher to the terminal
box. Wrap these wires over the nearby components or clip them
back into the nearby clips that they were routed through prior to
your removing the box, to help keep them off the floor.
Measure height of cabinet opening from underside of
countertop to floor where dishwasher will be installed (you will
need to measure the lowest point on the underside of the
countertop and the highest point on the floor). Refer to
"Dishwasher Height Adjustment Chart" for wheel position and
for wheel position and height of front legs needed for your
cabinet opening height.
Dishwasher Height Adjustment Cha
Cabinet opening Front legs Wheel Insulation
height height position blanket
331/2'' 3/8,,
(85.1 mm) (9.8 mm) Removed Cut
34" %"
(86.4 cm) (22 mm) 1 No cut
341/4'' 1"
(87.0 cm) (25 mm) 2 No cut
34W' ! 1/8"
(87.6 cm) (28.8 mm) 3 No cut
NOTE= If the minimum cabinet opening height is less than 34"
(86.4 cm), the rear wheels can be removed for additional
clearance. This will allow the dishwasher and perforated section
of the insulation blanket to fit into a 331/2" (85.1 cm) high
cabinet opening, but the dishwasher will be more difficult to
move. Measurements are approximate. Wheels and legs are
preset at the factory for 341/2'' (87.6 cm).
Cut insulation blanket along perforation
Cut insulation blanket along perforation for cabinet opening
height of 331/2'' (85.1 cm). For other cabinet opening heights, do
not cut.
]5
Loading ...
Loading ...
Loading ...