Loading ...
Loading ...
Loading ...
INSERTER
3-18
Troubleshooting inserter problems
Check the list below before calling for service.
Problem Check Solution or cause
Stapling position is
not correct
(including saddle
stitch).
The desired staple mode is not selected.
Select the desired staple mode at the
operation panel of the inserter (page 3-15).
The paper is not loaded in the correct
position.
Load the paper correctly (page 3-16).
The paper is not loaded face up.
Paper must be loaded face up in the inserter
tray (page 3-16).
The inserter does
not operate.
Are any inserter covers open? Close all covers.
"Disabling of inserter" is enabled in the
administrator settings.
Check the administrator settings and disable
"Disabling of inserter".
A paper misfeed message appears. Remove the misfed paper (page 3-17).
The [START] key light is not illuminated.
Make sure that the punch or staple key has
been selected on the operation panel of the
inserter (page 3-15).
Paper misfeed
occurs
The paper is curled or damp.
Do not use curled or folded paper. When the
inserter is not going to be used for a long time,
remove the paper from the inserter, place it in
a bag so that it does not absorb moisture, and
store it in a cool and dark place.
A paper misfeed
occurs when paper
is fed from the
inserter.
Do the size and orientation of the loaded
paper match the paper size and orientation
set in "Setting the paper type and paper
size"?
Make sure paper size and orientation set in
"Setting the paper type and paper size" match
the size and orientation of the loaded paper.
A message appears
each time paper is
placed in the paper
tray of the inserter.
Was the [SIZE SELECT] key touched and
the size and orientation of the paper for the
inserter set as explained in "Setting the
paper type and paper size"?
To ensure that the correct paper (size and
orientation) is loaded in the inserter, the
machine indicates the current paper size
setting each time paper is placed in the paper
tray.
dragonII_copy_sec.book 18 ページ ２００６年１０月１８日 水曜日 午後７時３９分
Loading ...
Loading ...
Loading ...