Loading ...
Loading ...
Loading ...
Checking and Replacing Wiper
Blades
Caution: Wiper blades do not lock into a
lifted position. When cleaning or
replacing a wiper blade, lift the wiper arm
only a short distance from the windshield,
just far enough to access the blade. Do
not lift a wiper arm beyond its intended
position. Doing so can cause damage that
is not covered by the warranty.
To make wiper blades easy to access, turn o
the wipers, shift Model S into Park, then use
the touchscreen to move them to the service
position. Touch Controls > Settings > Service
& Reset > Service Mode > ON.
Note: Wipers automatically return to their
normal position when you shift Model S out of
Park.
Periodically check and clean the edge of the
wiper blade and check the rubber for cracks,
splits and roughness. If damaged, replace the
blade immediately to prevent damage to the
glass.
Contaminants on the windshield, or on the
wiper blades, can reduce the
eectiveness of
the wiper blades. Contaminants include ice,
wax spray from car washes, washer fluid with
bug and/or water repellent, bird droppings,
tree sap, and other organic substances.
Follow these guidelines for cleaning:
• Clean the windshield using non-abrasive
glass cleaner.
• Lift the wiper arm a short distance away
from the windshield, just far enough to
access the wiper blade, then wipe the
blade clean using isopropyl (rubbing)
alcohol or washer
fluid.
If the wipers remain ineective after cleaning,
replace the wiper blades.
Note: For optimum performance, replace the
wiper blades at least once a year.
To replace the wiper blades:
1. Turn o the wipers, shift Model S into
Park, then use the touchscreen to move
the wipers to the service position. Touch
Controls > Settings > Service & Reset >
Service Mode > ON.
Note: The wipers must be
o to turn
Service Mode on.
2. Lift the wiper arm a short distance away
from the windshield, just far enough to
access the wiper blade.
3.
Hold the wiper arm (the wiper arm does
not lock into a lifted position) and press
the locking tab while sliding the blade
down the arm.
4. If necessary, temporarily place a towel
between the wiper arm and windshield to
avoid scratching the windshield.
5. Align the new blade on the wiper arm and
slide it toward the hooked end of the arm
until it locks into place.
6. Place the wiper arm against the
windshield.
7. Turn Service Mode
o.
If the problem persists with new blades, clean
the windshield and wiper blades by wiping
them with a soft cloth or sponge moistened
with warm water and non-detergent soap.
Then, rinse the windshield and wiper blades
with clean water. The windshield is clean when
water beads do not form.
Caution:
Only use cleaning products
approved for use on automotive glass and
rubber. Inappropriate products can cause
damage or smears, and create glare on
the windshield.
Caution: Only install replacement blades
that are identical to the original blades.
Using inappropriate blades can aect the
operation of the rain sensor and damage
the wiper system and windshield.
Cleaning Washer Jets
The position of the windshield washers is set
at the factory and should never need
adjusting.
If a windshield washer becomes blocked, use a
thin strand of wire to clear any blockages from
the nozzle.
Wiper Blades and Washer Jets
Maintenance 157
Loading ...
Loading ...
Loading ...