Loading ...
Loading ...
Loading ...
PREPARATIONS ➤ Initial settings En 33
• It is normal for loud test tones to be output during the AUTO SETUP procedure.
Make sure that there are no children around in the listening room while the AUTO
SETUP procedure is in progress.
• If there are curtains in your listening room, we recommend following the procedure
below.
1. Open the curtains to improve sound reflection.
2. Run “BEAM OPTIMIZE ONLY” (p. 34).
3. Close the curtains.
4. Run “SOUND OPTIMIZE ONLY” (p. 34).
• Make sure that your listening room is as quiet as possible. For accurate
measurement, turn off air conditioner or other devices that make noises.
1
Turn the unit and your TV on.
2
Switch TV input to display video input from this unit
(p. 30).
3
Connect the IntelliBeam microphone to the
INTELLIBEAM MIC jack of the unit.
The screen below is displayed after connecting IntelliBeam
microphone to the unit.
“AUTO SETUP” in the “IntelliBeam” menu can automatically
adjust the following two settings.
“BEAM OPTIMIZE ONLY” or “SOUND OPTIMIZE ONLY”
can be measured separately in the setup menu (p. 34).
• Follow the instructions below and then leave the room. If you remain in the
room, you may obstruct the beam, or the microphone may pickup any
sounds you make, possibly resulting in improper measurement.
4
Press the ENTER key to start the AUTO SETUP
procedure and then leave the room within 10
seconds.
The screen automatically changes during the AUTO
SETUP procedure.
If the AUTO SETUP procedure is complete, this unit rings
the chimes.
Using AUTO SETUP (IntelliBeam)
PHONES INTELLIBEAM MIC
INTELLIBEAM MIC
IntelliBeam microphone
Cardboard
microphone stand
AUTO SETUP
(PREPARATION & CHECK)
Please connect the MIC.
Please place the MIC at least
1.8m/6ft away from Sound Pro-
jector. The MIC should be set
at ear level when seated.
Measurement takes about 3min.
After [ENTER] is pressed,
please leave the room.
[ENTER]:Start [RETURN]:Cancel
Beam
This feature optimizes the beam angle so that
the parameter best matches your listening
environment.
Sound
This feature optimizes sound quality for each
channel by measuring the acoustic
characteristics of the listening environment.
SHOW RESULT
MEASUREMENT COMPLETE.
[ENTER]:Save set-up.
[RETURN]:Do not save set-up.
ENVIRONMENT CHECK: Success
BEAM MODE: 5Beam/Plus2
AUTO SETUP START
Will begin in 10 sec.
Please leave the room.
----------
[RETURN]:Cancel
(After 3 min.)
ENTER
Loading ...
Loading ...
Loading ...