Loading ...
Loading ...
Loading ...
19
the upright position during the bucking cut
to separate the log from the stump. Watch
out for springpoles—they are dangerous.
Do not attempt to cut bent branches or
stumps which are under tension unless you
are professionally trained and competent to
do so.(See Fig.42)
Fig.42
MAINTENANCE AND STORAGE
WARNING
: When servicing, use only
identical replacement parts. Use of any
other parts may create a hazard or cause
product damage.
WARNING:
Always wear protective gloves
when performing any maintenance to the
chain saw.
WARNING:
To avoid serious personal
injury, remove the battery pack from the
chain saw before inspecting, cleaning,
or performing maintenance. A battery
operated tool with the battery pack inserted
is always on and can start accidently.
WARNING:
When cleaning the chain saw,
DO NOT immerse in water or other liquids.
WARNING
: Do not at any time let brake
uids, petrol, petroleum-based products,
penetrating oils, etc., come in contact with
plastic parts. Chemicals can damage,
weaken, or destroy plastic, which may
result in serious personal injury.
CLEANING
- After each use, clean debris from the chain
and guide bar with a soft brush. Wipe
the chain saw surface with a clean cloth
moistened with a mild soap solution.
- Remove the side cover, and then use a soft
brush to remove debris from the guide bar,
saw chain, sprocket and side cover.
- Always clean out wood chips, saw dust,
and dirt from the guide bar groove when
replacing the saw chain.
REPLACING THE BAR AND CHAIN
WARNING:
Never touch or adjust the chain
while the motor is running. The saw chain
is very sharp.
NOTE:
When replacing the guide bar and
chain, always use the specied bar and chain
combination listed in the manual.
Disassemble the Worn Bar and Chain
1. Remove the battery, allow the saw to cool
and tighten the oil tank cap.
2. Position the chain saw on its side with the
side cover facing upwards.
3. Wear gloves. Remove the side cover by
turning the side cover knob anti-clockwise.
Clean the side cover with a dry cloth.
NOTE:
This is a good time to inspect the drive
sprocket for excessive wear or damage.
Assemble The New Bar And Chain
Follow the instructions in the ASSEMBLING/
REPLACING THE BAR AND CHAIN section in
this manual.
Adjust The Chain Tension
Follow the instructions in the ADJUSTING THE
CHAIN TENSION section in this manual.
CHAIN MAINTENANCE
WARNING:
Always wear gloves when handling
the saw chain; these components are sharp and
may contain burrs.
Use only low-kickback chains on this saw. This
fast cutting chain will provide kickback reduction
when properly maintained.
Loading ...
Loading ...
Loading ...