Loading ...
Loading ...
Loading ...
14
WARNING
: Do not smoke or bring any re
or ame near the oil or the chain saw. Oil
may spill and cause a re.
NOTE:
The chain saw is not lled with oil at the
time of purchase. It is essential to ll the tank
with oil before use.
The chain is automatically lubricated with chain
oil during operation.
1. Position the chain saw on its side with its oil
tank cap facing towards.
2. Clean the cap as well as the area around
and then turn it anti-clockwise to remove.
3. Carefully pour the specically designed oil
into the tank until reaching the bottom of the
lter neck.
4. Wipe off any excessive oil and replace the
cap.
NOTE:
With upright position, oil should ll the
inspection window. When the oil is no longer
visible in the inspection window, stop use
immediately and rell.
Inserting and removing the battery pack
NOTE:
Hold the tool and the battery pack rmly
when installing or removing the battery pack.
Failure to hold the tool and the battery pack
rmly may cause them to slip off your hands and
result in damage to the tool and battery pack,
potentially causing a personal injury.
Insert the battery pack. (Fig. 19)
To install the battery pack, align the tongue on
the battery pack with the groove in the housing
and slip it into place.
NOTE:
Always insert it all the way until it locks in
place with a little click. If not, it may accidentally
fall out of the tool, causing injury to you or
someone around you.
Fig.19
Remove the battery pack.
1. Depress the battery releasing/locking button
on the housing.
2. The battery pack will pop up automatically.
3. Lift and hold the battery pack while pressing
the releasing/locking button again, and then
remove the battery pack.
ATTENTION:
Battery Installation
INSTALLATION:
Battery lock has 2 positions.
Press down frmly until battery is fully inserted.
REMOVAL:
Press release button once,
hold battery frmly, press release button again,
Pull battery out.
Note!
The second operation that needs to be
performed when removing the battery pack is to
avoid any mis-operations at work, especially for
the 60VRX hand-held tools, in case the battery
pack falls and hurts consumers. (Fig. 20)
Fig.20
NOTE:
Do not use force when installing the
battery pack. If the battery pack does not slide in
easily, it is not being inserted correctly.
WARNING
: Verify that the switch is in the
OFF position before inserting or removing
the battery pack.
WARNING:
Verify that the battery pack
is removed and the switch is in the OFF
position before inspecting, adjusting or
performing maintenance on any part of the
chain saw.
Starting/stopping the chain saw
NOTE:
1. Before starting the chain saw, check for the
oil level, saw teeth sharpness and properly-
working kickback brake handle.
2. Besides, balanced footing and proper
distance away from the ground are needed.
To Start
1. Pull the chain kickback brake handle
towards the front handle to the operating
position. (Fig. 21)
Loading ...
Loading ...
Loading ...