Loading ...
Loading ...
Loading ...
19
Caution!
The cooking hob becomes very hot
during operation.
Keep children well out of reach.
Figure 10
LIGHTING THE BURNERS
To ignite the burner, the following
instructions are to be followed:
1. Press in the corresponding knob and
turn counter-clockwise (g. 10) to the
full ame position marked by the “
”
symbol (g. 9); press and hold the knob
to light the burner (the green indicator
light on the knob will blink to show that
burner ignition is in progress).
In the case of a mains failure light the
burner with a match or lighted taper.
If your local gas supply makes it
difcult to light the burner with the
knob set to maximum, set the knob to
minimum and repeat the operation.
2. Wait for a few seconds after the gas
burner has been lit before letting go
of the knob (valve activation delay)
until the green indicator light switches
from blinking to steady and a beep is
emitted.
3. Adjust the gas valve to the desired
position.
If the burner ame should be extinguished
for any reason, the electronic system
will automatically activate a procedure
to re-light the extinguished burner with
several sparks generated by the electronic
ignition system. For safety reasons (e.g.
to avoid possible gas accumulation do not
attempt to re-light a burner that has been
extinguished by a liquid spill) the automatic
re-ignition procedure will be performed
once only.
If the ame cannot be relit by means of the
automatic procedure the safety valve will
automatically shut off the gas ow, the red
residual heat warning light "H" will blink and
an audible alarm signal (beep) will sound;
turn the knob to the “
” position to mute
the audible signal.
Before proceeding with manual ignition
(starting from the above point 1) wait for at
least 1 minute and check that the burner
is correctly positioned (as illustrated in the
cleaning and maintenance chapter in the
heading concerning correct positioning of
the burners) and that it has not been fouled
by liquid spills.
IMPORTANT NOTE: In the case of an
electrical power failure, if the burner
ame should go out for some reason, the
safety valve will automatically stop the gas
ow.
To restore operation of the appliance return
the knob to the “
” position, wait at least
1 minute and then repeat the ignition
operations starting from the above point
1. In this case, since the electronic ignition
system is not working due to the power
failure, the burner must be lit with a match
or taper.
IMPORTANT NOTE:
Supervise the hob when it is in use to
ensure it is working correctly.
Never leave the appliance unattended
when it is in use.
Loading ...
Loading ...
Loading ...