Loading ...
Loading ...
Loading ...
11
GAS SUPPLY
■ This appliance is suitable for use
with Natural Gas or ULPG (Check
the “gas type” sticker attached to the
appliance).
■ For Natural Gas the gas supply must
be regulated to obtain a pressure of
1 kPa with the triple-ring (TR) burner
operating at the maximum.
■ For ULPG models connect the gas
supply directly to the appliance test
point adaptor (supplied with the
conversion kit) and ensure that the
supply pressure is regulated to 2.75
kPa.
■ Do NOT force the ”elbow“ rotation
prior to loosening nut.
■ Do NOT over tighten the nut at the
”elbow“.
1. After connecting the gas supply, check
the piping and connections for leaks
using a soap and water solution. The
presence of bubbles indicates a leak,
tighten or replace connections as
appropriate.
Warning: Do not use any naked ame
to check for leaks.
2. The operation of the appliance MUST
be tested before leaving.
3. Adjust the test point pressure or
supply pressure to the value which is
appropriate for the gas type.
Gas connection for
NATURAL GAS
Gas inlet pipe
Gasket
Brass conical adaptor
(Thread tight: use
suitable seal)
Gas regulator
Test
point
Gas connection for
ULPG
Test point adaptor
Gasket
Gas inlet pipe
Test
point
Brass conical adaptor
(Thread tight: use
suitable seal)
Figure 4a
Figure 4b
Figure 4c
Loading ...
Loading ...
Loading ...