Loading ...
Loading ...
Loading ...
14
TECHNICAL SPECIFICATIONS
Product type: 734
Intended use: Abdominal muscle stimulator
Waveform: Symmetrical bi-phasic square waveform when measured into a resistive load.
Accessories
Under no circumstances should anything other than
SLENDERTONE accessories be used with your SLENDERTONE COREFIT product
(Type 734). Any others may not be compatible with your product and could degrade the minimum safety levels. You can
purchase all accessories from www.slendertone.com or by calling customer care.
SLENDERTONE COREFIT Belt
SLENDERTONE Abs GelPads: • 1 large, square GelPad (Type 732)
• 2 small, oval GelPads (Type 733)
USB Cable: Type A to Micro B USB Charger
N
OTE:
The signal gradually increases to a peak intensity level at the start of the contraction phase (i.e. ramp up) and gradually decreases to
nothing at the start of the relaxation phase (i.e. ramp down). When the symbol is flashing, the stimulus is significantly reduced.
Environmental Specifications:
Operating Range: Temperature: 41 to 104°F
Humidity: 15 to 93 % RH (non-condensing)
Atmospheric Pressure: 70 to 106kPa
Transport & Temperature: -13 to 158°F
Storage Range: Humidity: 10 to 93 % RH (non-condensing)
Atmospheric Pressure: 50 to 106kPa
The time required to reach optimal operating temperature range from transport and storage temperature range is up to 20 minutes,
depending on the ambient temperature.
The Output Frequency indicates the number of pulses per second transmitted by the controller. This is measured in hertz,
which is indicated by “Hz”.
Output (RMSA) means the maximum output root mean square current for each channel.
Output (RMSV) means the maximum output root mean square voltage for each channel.
Attention: This product can deliver currents in excess of 2mA/cm² if used with incorrect electrodes.
Description of your unit’s symbols:
There are a number of technical markings on your controller. These can be explained as follows:
The product is manufactured for Bio-Medical Research Ltd, Parkmore Business Park West, Galway, Ireland.
This symbol means “Attention, consult the accompanying documents”.
This symbol means type BF applied parts (electrodes).
This symbol on your product is to indicate conformity to the requirements of the EMC Directive (2014/30/EU). The CE mark
applied also indicates that this equipment complies with the requirements of the ROHS Directive 011/65/EU) for the
Restriction of Hazardous Substances in Electrical and Electronic Equipment.
SN stands for serial number. On the label on the back of the controller is the serial number specific to this product. The letter
preceding the number indicates the year of manufacture, where ‘X’ denotes 2018, ‘Y’ denotes 2019 etc.
The belt’s batch number is represented by the lot number label located underneath the wash label, by the number corresponding
with the LOT symbol.
IP22 Ingress Protection Rating - this means it is protected against access to hazardous parts with a finger and against vertically
falling water drops when tilted up to 15 degrees.
At the end of the product lifecycle, do not throw this product or batteries into the normal household garbage, but bring it
to a collection point for the recycling of electronic equipment. Some product materials can be re-used if you bring them to
a recycling point. By re-using some parts or raw materials from used products you make an important contribution to the
protection of the environment. Please contact your local authorities if you need more information about collection points in your
area. Waste Electrical and Electronic Equipment can have potentially harmful effects on the environment. Incorrect disposal can
cause harmful toxins to build up in the air, water and soil and can be harmful to human health.
See page 16.
Loading ...
Loading ...
Loading ...