Loading ...
Loading ...
Loading ...
TEC_TM_009 Rev. B
December 31, 2019 Page 45 of 50
FREEZER STORAGE
WIRE SHELVES
Remove the top foam piece holding the wire shelves. Carefully remove shelves and set aside. Remove all other
packing material. To install, insert wire shelf into the shelf standards on the back wall, with the front tilted upward,
and then lower the front until it stops. To remove or adjust a wire shelf, tilt up, and then lift up and out.
WIRE BASKETS
To remove a basket, pull drawer forward until it stops. Use a Phillips screw driver to remove the two (2) screws
securing the basket to the slides, then lift the basket up and out of unit. To reinstall, pull drawer slides all the way
forward on unit, and then slide the basket onto the slides until the hook on the back of the slide is over top of the
rails, reinstall the screws using the Phillips screw driver.
REMOVING THE DOORS
Open the top louver grill. With the door open at 90 degrees, lift the door straight up and out of the hinges.
To re-install, hold the door 90 degrees to the opening and align hinge posts to the hinges. Lower the door into place.
KICK PLATE INSTALLATION
The kick plate is shipped with the unit but not attached to allow access to level the unit. Once the unit is level,
the kick plate attaches to the front, bottom of the unit with magnets located on the left and right.
KICK PLATE MAGNETSKICK PLATE INSTALLED KICK PLATE
FINAL WIRE SHELF INSTALLATION
Loading ...
Loading ...
Loading ...